Dewalt DW723 Instruction Manual - Page 6
Warning - manual
View all Dewalt DW723 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
English WARNING: For your own safety, read and understand the miter saw instruction manual before using. Failure to heed these warnings may result in personal injury and serious damage to the miter saw and the accessory. 13. The miter saw MUST be positioned so all four corners can be bolted squarely to the mounting brackets. If this is not possible, please call DEWALT Customer Support at 1-800-4-DEWALT (1-800-433-9258) for technical assistance. NOTE: If the saw mounting holes do not line up with the slots in the mounting brackets, mount the saw to a piece of 3/4" (19 mm) plywood. The plywood must be a minimum of 4" (101.6 mm) wider than the miter saw base being mounted and a minimum depth of 16" (406.4 mm). Plywood must be at least as deep as the saw base being mounted. Place the mounting brackets on the stand and mount the plywood board to the mounting brackets exactly as shown in figure. Drill 3/8" (9.4 mm) holes 1" (2.5 mm) from each end to secure plywood to mounting brackets. Other hardware (not supplied) may be necessary under these circumstances. NOTE: All purchased hardware must be a minimum of Grade 2. Hardware should be 1-1/4" (31,8 mm) longer than the saw base you are assembling. NOTE: If the saw mounting holes do not line up with the slots in the mounting brackets and the method of utilizing plywood does not accommodate your saw, please call 1-800-4-DEWALT (1-800-4339258) for additional hardware to install your miter saw. WIDTH OF SAW + 4" (101.6 mm) 1" (2.5 mm) 1" (2.5 mm) MINIMUM OF 16" (406.4 mm) MUST BE AT 15" LEAST AS ((381 mm) DEEP AS THE BOTH SAW BEING SIDES MOUNTING MOUNT MITER SAW IN SHADED AREA 3/8" (9.5 mm) DIAMETER HOLES, ALL 4 CORNERS 2" (50.8 mm) MINIMUM BOTH SIDES SAW BASE 3/4" (19 mm) PLYWOOD LOCK WASHER FLAT WASHER NUT 1" (2.5 mm) 1" (2.5 mm) 4