Epson CX7800 Product Information Guide - Page 7

Epson Stylus CX7800 Copying a Photo 1. Make sure the Epson Stylus CX7800 is turned on. 2. Place the photo on the glass as described on page 6. Be sure to close the document cover. 3. Load up to 20 sheets of letter-size, 4 × 6-inch, or 5 × 7-inch photo paper, as described on page 4. 4. Press the Film/Photo mode button. 5. Press the l or r Photo/Options button to select Copy Photograph. When Restoration ON is also selected, the photo is copied with color restoration on. For more information, see page 9. 6. Press the x Start button. The P On light flashes and the Epson Stylus CX7800 scans the photograph and displays it on the LCD screen. 7. Press the u or d Copies button to select the number of copies. 8. Press the paper type button to select Photo Paper. 9. Press the paper size button to select Letter, 4"x 6", or 5"x7". 10. Press the x Start button. The P On light flashes and the Epson Stylus CX7800 starts printing. To cancel copying, press the y Stop/Clear Settings button. Do not pull out paper that is being printed; it will be ejected automatically to the output tray. Note: The copies may not be exactly the same size as the original. Making Prints from Slides or Negatives You can use the film holder that came with your Epson Stylus CX7800 to scan 35 mm slides, or strips of negative and positive film. To get professional results that look and feel like traditional photos, try one of the special Epson papers listed on page 1. Before you scan and print see: ❏ "Placing 35mm Slides in the Holder" (see below) ❏ "Placing 35mm Film Strips in the Holder" on page 7 Placing 35mm Slides in the Holder 1. Open the document cover and remove the document mat. Pull up on the fastener at the top of the document mat. Then pull out the mat. 2. Place the film holder's tabs into the two small holes at the left edge of the glass. Make sure the cutouts for 35mm slides are toward the back of the glass to align them with the fluorescent lamp when you close the document cover. Fluorescent lamp 3. Place your slides in the film holder in the orientation shown below with the shiny side up. Note: Make sure there is no gap between the holder and the document table; otherwise the prints may not be clear. Continue with the steps on page 8 to scan and print your photos. Placing 35mm Film Strips in the Holder 1. Open the document cover and remove the document mat. Pull up on the fastener at the top of the document mat. Then pull out the mat. 8/05 Epson Stylus CX7800 - 7