Epson Stylus COLOR 3000 Service Manual - Page 100
CR Unit Removal, CR Unit Removal
View all Epson Stylus COLOR 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
EPSON Stylus COLOR 3000 3.2.11.14 CR Unit Removal 1. Remove the printer mechanism unit. (See Section 3.2.6.) 2. Disconnect the HP sensor connector cable from the HP sensor. 3. Remove the belt tension spring to loosen the timing belt. 4. Disengage the timing belt from the pulley on the CR motor and the sub pulley. 5. Remove 1 E-ring and 1 plain washer (6X0.7X12) from each end of the CR guide shaft. 6. If the head cleaner lever* is locking the CR unit, push the lever down manually to unlock the CR unit. * Head cleaner lever: See Figure 3-20. 7. Remove 1 screw (CBS, 3X6) and 2 CR mounting shafts securing the black and the color cables with the head cable guide to the base frame assembly. Then remove the head cable guide and tube mounting plate, and remove the ink tubes from the printer mechanism. 8. Release the coupling screws connecting the ink tubes to the ink tube unit. Then remove the tubes. 9. Turn the parallelism adjust bushings joining the CR guide shaft to the right and left frame assemblies and release the bushings. Then remove the CR unit along with the CR guide shaft. 10.Remove the CR guide shaft from the CR unit. Figure 3-27. CR Unit Removal Rev. A 3-31