Epson Stylus COLOR 3000 Service Manual - Page 38
Error Condition, the error status
View all Epson Stylus COLOR 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
EPSON Stylus COLOR 3000 1.5.8 Error Condition When any of the conditions listed below is detected, the printer goes into an error status and the /ERROR signal goes LOW and the BUSY signal goes HIGH. On this condition, the printer accepts no data and goes into a pause status automatically. The CR moves abnormally. (Fatal error) Paper ends or paper is jamming. Release lever position is inappropriate for the paper path currently used. No ink cartridge is installed or ink ends. Maintenance is required. Table 1-36. Printer Condition and Panel Status (2) LED Indicators Printer Condition Paper Pause Ink Out Media Out Type Power on On Capping function in the power off Blinks Data exit Blinks Paper Out On Paper jam Blinks Pause On During ink sequence Blinks No color ink cartridge or ink out Corresponding color goes on. Ink Low (color) Corresponding color blinks. No black ink cartridge or ink out On Ink Low (black) Blinks Lever error Blinks Fatal error Blinks Blinks Blinks Blinks Blinks Blinks Blinks Blinks Maintenance request Blinks Blinks Blinks On On On On Blinks Panel reset function On for 1 second only. Reset EEPROM and Timer IC On for 1 second only. Note) 1. "" means no effect. 2. To recover from the fatal error, turn off and back on the printer or send the /INIT signal after eliminating the trigger. 3. Maintenance request occurs when the wasted ink fills to capacity, and servicing is required. To clear the error status, perform EEPROM reset. (See Table 1-29. Panel Function with Power On, Chapter 2 and Chapter 3.) 4. Refer to Table 1-30 for detailed conditions indicated by the Media type LED indicators. Rev. A 1-31