Epson Stylus COLOR 3000 Service Manual - Page 130
Sensor, Connector No., Test pin No., Signal level, Detected condition, Troubleshooting, Rev.
View all Epson Stylus COLOR 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Troubleshooting Table 5-2. Sensor Status Sensor Connector No. Test pin No. Signal level Detected condition HP sensor CN6 Pin 1 and Pin 2 Close ∗1 Open ∗2 In the false absorbing position Off the false absorbing position Rear PE sensor CN5 HIGH Paper loaded Pin 1 and Pin 2 LOW No paper loaded Front PE sensor CN4 HIGH Paper loaded Pin 1 and Pin 2 LOW No paper loaded Release sensor CN3 HIGH Tractor feed mode Pin 1 and Pin 2 LOW Friction feed mode Black ink cartridge CN14 HIGH No black ink cartridge installed sensor Pin 3 and Pin 4 LOW Black ink cartridge installed Cyan ink cartridge CN13 HIGH No cyan ink cartridge installed sensor Pin 3 and Pin 4 LOW Cyan ink cartridge installed Magenta ink cartridge CN7 HIGH No magenta ink cartridge installed sensor Pin 3 and Pin 4 LOW Magenta ink cartridge installed Yellow ink cartridge CN12 HIGH No yellow ink cartridge installed sensor Pin 3 and Pin 4 LOW Yellow ink cartridge installed Black ink end sensor CN14 HIGH Black Ink end Pin 1 and Pin 2 LOW Black Ink remaining Cyan ink end sensor CN13 HIGH Cyan Ink end Pin 1 and Pin 2 LOW Cyan Ink remaining Magenta ink end CN7 HIGH Magenta Ink end sensor Pin 1 and Pin 2 LOW Magenta Ink remaining Yellow ink end sensor CN12 HIGH Yellow Ink end Pin 1 and Pin 2 LOW Yellow Ink remaining ASF PW sensor CN8 Pin 2 and Pin 4 Analog data Maximum 10kΩ ASF PL sensor CN11 HIGH Not set Pin 1 and Pin 2, Pin 3 and Pin 4, Pin 5 and Pin 6 LOW Set ASF PQ sensor CN10 Pin 3 and Pin 2 Analog data Maximum 10kΩ Platen gap sensor CN9 HIGH Thick paper side Pin 1 and Pin 2 LOW Thin paper side CR PW sensor CN21 HIGH Paper detected Pin 24 and Pin 25(GND) LOW No paper detected Thermistor CN18 Pin 2 and GND Analog data Maximum 10kΩ (at 24°C) ∗1: When it is close, output voltage level is 2.5 or higher. ∗2: When it is open, output voltage level is lower than 2.5V. 5-2 Rev. A