Fisher and Paykel RDV3-304-N Installation Guide - Page 4

SAFETY AND WARNINGS WARNING! To avoid hazard, follow these instructions carefully before installing or using this appliance. z Please make this information available to the person installing the appliance - doing so could reduce your installation costs. z Save these instructions for the local inspectors use. z This range is to be installed and connected to the electricity supply only by an authorized person. z If the installation requires alterations to the domestic electrical system, call a qualified electrician. The electrician should also check that the socket cable section is suitable for the electricity drawn by the range. z Service should only be done by authorized technicians. Technicians must disconnect the power supply before servicing this appliance. z The range must be grounded. z Installation must comply with your local building and electricity regulations. z This appliance must be installed and connected to the mains power supply only by a suitably qualified person according to these installation instructions and in compliance with any applicable local building and electricity regulations. Failure to install the appliance correctly could invalidate any warranty or liability claims. z Ensure the installer shows the customer where the gas supply shut-off valve is located. z If the power supply cable is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard. z A circuit breaker is recommended. z Do not use adaptors, reducers or branching devices to connect the oven to the mains electricity supply, as they can cause overheating and burning. z Improper installation, adjustment alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before using, installing or servicing this appliance. z A risk of the appliance tipping over exists if the appliance is not installed in accordance with installation instructions. z DO NOT obstruct the flow of combustion or ventilation air to the appliance. Be sure a fresh air supply is available. z California Proposition 65 - The burning of gas cooking fuel generates some by-products which are known by the State of California to cause cancer or reproductive harm. California law requires businesses to warn customers of potential exposure to such substances. To minimize exposure to these substances, always operate this unit according to the manufacturer's instructions and provide good ventilation to the room when cooking with gas. z Check local building codes for the proper method of range installation. Local codes vary. Installation, electrical connections, and grounding must comply with all applicable codes. In the absence of local codes, the range should be installed in accordance with the latest edition of National Fuel Gas Code ANSI Z223.1 and National Electrical Code ANSI / NFPA 70. z In Canada: Installation must be in accordance with the current CAN/CGA B149.1 & 2 Gas Installation codes and/or local codes. Electrical installation must be in accordance with the current CSA C22.1 Canadian Electrical Codes Part 1 and/ or local codes. z Be sure that the unit being installed is set up for the kind of gas being used. The gas range is shipped from the factory set and adjusted for Natural Gas or LP (propane), depending on the specific model ordered. Verify that the range is compatible with the gas at the installation site before proceeding further. Return range to dealer if the unit is not set for site gas supply. z The appliance must not be installed behind a decorative door in order to avoid overheating. z Do not lift the range by the door handle. Doing so may damage the product. z Before use, ensure all doors are correctly installed. z Two persons are required to move the product safely to the installation location. IMPORTANT! SAVE THESE INSTRUCTIONS 4