Fisher and Paykel RF170WLKUX6 Installation Guide - Water Filter Replacement - Page 3

1 SAFETY AND WARNINGS Water filter IMPORTANT! ● The water connection to your ice & water refrigerator must be installed by an qualified plumber or Fisher & Paykel trained and supported service technician and comply with all state and local laws. ● Installation and use MUST comply with all state and local plumbing codes. Check with your local public works department for plumbing codes. You must follow their guidelines as you install the water filtration system. ● To avoid serious illness or death, only connect your water filter to safe drinking water. ● The water filter cartridge needs to be changed when the replacement indicator icon illuminates. This will happen every 6 months. ● If the water filtration system has been allowed to freeze, replace filter cartridge. Failure to replace the disposable filter at recommended intervals may lead to reduced filter performance and failure of the filter, causing property damage from water leakage or flooding. ● In cases of excessively reduced filter life - we recommend that you consult a local plumber or your water supplier for advice on suitable filtration requirements for the water supplied to your home. ● Filter replacement is the consumer's responsibility and will not be covered by the warranty except in the case of faulty parts or materials within the filter cartridge. ● If the water has not created ice for some time or ice has an unpleasant taste or odor dispose of ice and refer to the flushing instructions in this book. If unpleasant taste or odor persists, you may wish to fit a new filter cartridge. ● Your water filtration system can withstand up to 120psi (827kPa) of water pressure. If a pressure reducing valve was supplied with your product, this must be installed before the water filtration system. DO NOT install if water pressure exceeds 120psi (827kPa). To reduce the risk associated with property damage due to water leakage or flooding: ● DO NOT install systems in areas where ambient temperatures may go above 100°F (38°C) or drop below 33°F (0.6°C). ● DO NOT install on hot water supply lines. The maximum operating water temperature of this filter system is 100°F (38°C). ● DO NOT install where water hammer conditions may occur. If water hammer conditions exist, you must install a water hammer arrester. 847200 - Certified by: IAPMO R&T against NSF/ANSI Standards 43, 53, 401 and CSA B4831.1 for the reduction of claims specified on the performance data sheet and at iapmort.org. 847200 compounds certified under NSF/ANSI 401 have been deemed as incidental contaminants/emerging compounds. Incidental contaminants are those compounds that have been detected in drinking water supplies at trace levels. While occurring at only trace levels, these compounds can affect the public acceptance of drinking quality water. 847201 - Certified by: IAPMO R&T against NSF/ANSI Standards 43 and CSA B4831.1 for the reduction of claims specified on the performance data sheet and at iapmort.org. Rated capacity 847200 - 102 gallons (386 litres) 847201 - 170 gallons (643 litres) Flow rate 0.5 gpm (1.89 Lpm) Replacement filter cartridges can be purchased online at fisherpaykel.com or by calling Fisher & Paykel Customer Care. Details of the replacement filter cartridge are labelled on the cartridge. Office address Fisher & Paykel Appliances Ltd PO Box 58550 Botany Auckland 2163 New Zealand Customer Care Phone: +64 9 273 0660 1