Frigidaire FEQ332ES Installation Instructions (All Languages) - Page 8
Electrical Connections, For 3-wire System, For 4-wire System - electric dryers
UPC - 012505374395
View all Frigidaire FEQ332ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
GREEN GROUND SCREW NEUTRAL GROUND WIRE SILVER TERMINAL GREEN GROUND SCREW GREEN POWER CORD GROUND WIRE SILVER TERMINAL TERMINAL BLOCK NUT TIGHTEN NUT TO THESE THREADS NEUTRAL GROUND WIRE RED BLACK TIGHTEN NUT WHITE TO THESE THREADS NUT STRAIN RELIEF MOUNTING BRACKET STRAIN RELIEF MOUNTING BRACKET POWER CORD POWER CORD ELECTRICAL CONNECTIONS FOR 4-WIRE SYSTEM Non-Canadian ELECTRIC Dryer ELECTRICAL CONNECTIONS FOR 3-WIRE SYSTEM Non-Canadian ELECTRIC Dryer 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a U.L. approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten the nut only at this time. 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a U.L. approved strain relief in the entry hole of the mounting bracket. Finger tighten the nut only at this time. 3. Remove the ground wire from the green ground screw located above the terminal block. TYPICAL 4 CONDUCTOR RECEPTACLE BLACK 240V WHITE NEUTRAL 3. Thread a U.L. approved 30 amp. power cord, NEMA 10-30 Type SRDT, through the strain relief. 4. Attach the power cord neutral (center wire) conductor to the silver colored center terminal on the terminal block. Tighten the screw securely. 5. Attach the remaining two power cord outer conductors to the outer brass colored terminals on the terminal block. Tighten both screws securely. Do not make a sharp bend or crimp wiring/ conductor at connections. 6. Reattach the strain relief mounting bracket to the back of the dryer with two screws. Tighten screws securely. TYPICAL 4 CONDUCTOR CORD RED 240V GREEN GROUND 30 AMP NEMA 14-30 TYPE SRDT OR ST 4. Thread a U.L. approved 30 amp power cord, NEMA 14-30 type ST or SRDT through the strain relief. 5. Attach the green power cord ground wire to the cabinet with the green ground screw. 6. Attach the white (neutral) power cord conductor from the power cord and the ground wire from the dryer harness to the silver-colored center terminal on the terminal block. Tighten the screw securely. 7. Attach the red and black power cord conductors to the outer brass-colored terminals on the terminal block. 7. Tighten the screws securing the cord restraint firmly against the power cord. Do not make a sharp bend or crimp wiring/ conductor at the connections. 8. Tighten the strain relief nut securely so that the strain relief does not turn. 9. Reinstall the terminal block cover. 8. Tighten the screws securing the cord restraint firmly against the power cord. 9. Tighten the strain relief nut securely so the strain relief does not turn. 10. Reinstall the terminal block access cover. 8