Frigidaire GRSC2352AD Complete Owners Guide - Page 11
CAUTION, IMPORTANT, To Disconnect
View all Frigidaire GRSC2352AD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
11 DOOR REMOVAL To remove the freezer door: 1. Remove the 3 screws from the cover over the top door hinge. 2. Lift hinge cover straight up and off. To Disconnect 1. Press outer ring against face of fitting 2. Pull to remove tube To Connect Insert tube and push until mark touches face of fitting Door 3. Release the wires from the routing clip. IMPORTANT To prevent wire damage, ensure the wires are rerouted through the routing clip when reassembling the hinge cover. Closer Pin Water Line Tubing Hinge Hinge Assembly Screws Adjustable Hinge (some models) Door Water Line Tubing Hinge Assembly Screws Non-Adjusting Hinge (some models) Disconnect the multi-wire cable connector located above the top hinge. Press the cable and lock and separate the 2 cables. 8. Lay the door on its side to avoid damage to the water tube extending from the bottom hinge. To reinstall the freezer door, reverse the above steps. 4. Trace lightly around the hinge with a pencil. This makes reinstallation easier. 5. Detach the water tube from the connector located below the freezer door. The connector releases when you press its outer sleeve inward. CAUTION Be sure doors are set aside in a secure position where they cannot fall and cause personal injury. 6. Remove the 2 screws from the top hinge. Remove the hinge pulling the multi-wire cable through it. Lift the door off the bottom hinge. 7. Remove the 2 bottom hinge screws and hinge if necessary.