Frigidaire GRSC2352AD Complete Owners Guide - Page 30

30 TROUBLESHOOTING CONCERN CAUSE SOLUTION DISPENSER (Ice & Water) (Continued) Dispenser will not dispense water. • Water filter not seated properly. • Water filter is clogged. • Household water line valve is not open. • Remove and reinstall the water filter. Be sure to push the filter firmly so that you hear it lock solidly into position. • Replace filter cartridge. Be sure to remove protective caps and push the filter firmly so that you hear it lock solidly into position. • Open the household water line valve. Water has an odd taste and/ or odor. • Water has not been dispensed for an extended period of time. • Unit not properly connected to cold water line. • Draw and discard 10-12 glasses of water to freshen the supply. • Connect unit to cold water line that supplies water to the kitchen faucet. Water pressure is extremely low. • Cut-off and cut-on pressures are too low (well systems only). • Reverse osmosis system is in regenerative phase. • Have someone turn up the cut-off and cut-on pressure on the water pump system (well systems only). • It is normal for a reverse osmosis system to be below 20 psi during the regenerative phase. • See the WATER SUPPLY CONNECTION section. Water not cold enough. • As warmer tap water goes through the filter and enters the water tank the chilled water is pushed through to the dispenser. Once the chilled water is used up it will take several hours to bring the freshly replaced water to a cooler temperature. • Some models are designed without a water tank, these water dispensing systems are not designed to chill water. • Add ice to cup or container before dispensing water. • Add ice to cup or container before dispensing water OPENING/CLOSING OF DOORS/DRAWERS Door(s) will not close. • Door was closed too hard, causing other door to open slightly. • Refrigerator is not level. It rocks on the floor when moved slightly. • Refrigerator is touching a wall or cabinet. • Close both doors gently. • Ensure floor is level and solid, and can adequately support the refrigerator. Contact a carpenter to correct a sagging or sloping floor. • Ensure floor is level and solid, and can adequately support the refrigerator. Contact a carpenter to correct a sagging or sloping floor.