Frigidaire GRSC2352AD Complete Owners Guide - Page 24

24 FILTER REPLACEMENT 5. Push firmly until the cartridge Damper/Air snaps into place (you should hear a Filter Housing click as the cartridge engages the snap-in connector). 6. Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal. In humid regions certain products stored too close to the damper/air filter housing may freeze. If this scenario occurs, adjust the fresh 7. After filling one glass of water, con- food temperature tinue flushing the system for about settings and reconfigure the top shelf 4 minutes. storage to allow for proper air diffusion. 8. Turn On the ice maker. 9. Press and hold the Water Filter reset PureAir Produce Keeper™ button on the Ice & Water Dispenser control panel for 3 seconds. When Installing the PureAir Produce Keeper™: the display changes from red to 1. Remove the plastic wrapper. Insert green, the status has been reset. unopened packet into the holder in PureAir Ultra II™ Air Filter the Crisper Drawer. 2. For optimal results, replace the (some models) refill every 6 months along with your Some models are pre-loaded with an air air filter. filter located at the top of the fresh food compartment, next to the water filter. Replacing the Air Filter You should change your air filter every 6 months (the filter status light on the control panel prompts you to replace the filter after 6 months) to optimize the reduction of refrigerator odors. Different foods will emit various levels of odor. To install your new PAULTRA2TM PureAir Ultra II™ air filter: 1. Pull the air filter housing straight out. 2. Remove the old filter and discard it (if applicable). CAUTION DO NOT OPEN. Contents may irritate eyes or skin. Keep out of reach of children. FIRST AID: Contains potassium permanganate. In case of contact with eyes or skin, rinse immediately with water. DO NOT EAT: If swallowed, seek medical treatment immediately. 3. Unpack the new filter and place it inside the housing. 4. Slide the housing back into position. 5. Activate or reset the Air Filter status light on the control panel.