Garmin Edge 1000 Owner's Manual - Page 18

Changing the Configuration Settings You can modify all of the settings you configured in the initial setup. 1 Select > System > Device Reset > Initial Setup. 2 Follow the on-screen instructions. Time Zones Each time you turn on the device and acquire satellites, the device automatically detects your time zone and the current time of day. Device Information Specifications Edge Specifications Battery type Rechargable, built-in lithium-ion battery Battery life 15 hours, typical usage Operating temperature range From -20º to 60ºC (from -4º to 140ºF) Charging temperature range From 0º to 40ºC (from 32º to 104ºF) Water rating IEC 60529 IPX7* *The device withstands incidental exposure to water of up to 1 meter for up to 30 minutes. Heart Rate Monitor Specifications Battery type User-replaceable CR2032, 3 volts Battery life Up to 4. 5 years (1 hour per day) Operating temperature From -5° to 50°C (from 23° to 122°F) range Radio frequency/ protocol 2. 4 GHz ANT + wireless communications protocol Water rating 3 ATM* NOTE: This product does not transmit heart rate data while swimming. *The device withstands pressure equivalent to a depth of 30 meters. Speed Sensor and Cadence Sensor Specifications Battery type Battery life Operating temperature range Radio frequency/protocol Water rating User-replaceable CR2032, 3 volts Approximately 12 months (1 hour per day) From -20º to 60ºC (from -4º to 140ºF) 2. 4 GHz ANT + wireless communications protocol 1 ATM* *The device withstands pressure equivalent to a depth of 10 meters. Device Care NOTICE Do not store the device where prolonged exposure to extreme temperatures can occur, because it can cause permanent damage. Never use a hard or sharp object to operate the touch screen, or damage may result. Avoid chemical cleaners and solvents that can damage plastic components. Secure the weather cap tightly to prevent damage to the USB port. Cleaning the Device 1 Wipe the device using a cloth dampened with a mild detergent solution. 14 2 Wipe it dry. Caring for the Heart Rate Monitor NOTICE You must unsnap and remove the module before cleaning the strap. A build up of sweat and salt on the strap can decrease the ability of the heart rate monitor to report accurate data. • Go to www.garmin.com/ HRMcare for detailed washing instructions. • Rinse the strap after every use. • Machine wash the strap after every seven uses. • Do not put the strap in a dryer. • When drying the strap, hang it up or lay it flat. • To prolong the life of your heart rate monitor, unsnap the module when not in use. User Replaceable Batteries WARNING Do not use a sharp object to remove batteries. Keep the battery away from children. Never put batteries in mouth. If swallowed, contact your physician or local poison control center. Replaceable coin cell batteries may contain perchlorate material. Special handling may apply. See www.dtsc.ca.gov.hazardouswaste/ perchlorate. CAUTION Contact your local waste disposal department to properly recycle the batteries. Replacing the Heart Rate Monitor Battery 1 Use a small Phillips screwdriver to remove the four screws on the back of the module. 2 Remove the cover and battery. 3 Wait 30 seconds. 4 Insert the new battery with the positive side facing up. NOTE: Do not damage or lose the O-ring gasket. 5 Replace the back cover and the four screws. NOTE: Do not overtighten. After you replace the heart rate monitor battery, you may need to pair it with the device again. Replacing the Speed Sensor or Cadence Sensor Battery The LED flashes red to indicate a low battery level after two revolutions. 1 Locate the circular battery cover À on the back of the sensor. Device Information