Garmin LiveScope LVS32-IF Installation Instructions - Page 3

Installing the Transducer on a Trolling Motor - mount

Get Garmin LiveScope LVS32-IF PDF manuals and user guides View all Garmin LiveScope LVS32-IF manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

Routing the Transducer Cable You should test-fit the transducer and cable before installation. 1 Allow a loose gap of at least 10 cm ( 4 in.) above and 10 cm (4 in.) below the rotating joint to create a loop in the cable. The loop must be large enough to allow full rotation of the transducer in both directions. Allow a minimum of 25 cm (10 in.) of cable to cover the 20 cm (8 in.) section between mounting points. 2 Use black electrical tape to secure the transducer cable to the shaft. 3 Test the full rotation of the trolling motor to ensure the cable clears the rotating joint and is not pulled tight due to tension during rotation. Installing the Transducer on a Trolling Motor Assembling the Trolling Motor Barrel Mount Hardware 1 Align the top of the transducer with the top of the bracket . 2 Using the included hex wrench, attach the bracket to the transducer with the shoulder screw , rubber washer , and flat washer . NOTE: You must fully tighten the mount to the transducer. The recommended torque applied to the shoulder screw is 2.5 lb-ft. (3.4 N-m). 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
Routing the Transducer Cable
You should test-fit the transducer and cable before installation.
1
Allow a loose gap of at least 10 cm ( 4 in.) above and 10 cm (4 in.)
below the rotating joint
to create a
loop
in the cable. The loop must be large enough to allow full rotation of the transducer in both
directions. Allow a minimum of 25 cm (10 in.) of cable to cover the 20 cm (8 in.) section between mounting
points.
2
Use black electrical tape
to secure the transducer cable to the shaft.
3
Test the full rotation of the trolling motor to ensure the cable clears the rotating joint and is not pulled tight
due to tension during rotation.
Installing the Transducer on a Trolling Motor
Assembling the Trolling Motor Barrel Mount Hardware
1
Align the top of the transducer
with the top of the bracket
.
2
Using the included hex wrench, attach the bracket to the transducer with the shoulder screw
, rubber
washer
, and flat washer
.
NOTE:
You must fully tighten the mount to the transducer. The recommended torque applied to the shoulder
screw is 2.5 lb-ft. (3.4 N-m).
3