Garmin LiveScope LVS32-IF Installation Instructions - Page 4
Notice - orientation
View all Garmin LiveScope LVS32-IF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Installing the Transducer on a Trolling Motor NOTICE You must secure the transducer cable to the shaft or other secure location during installation. Damage to the transducer cable wires or cable jacket can cause transducer failure. 1 Insert the hose clamp through the slot on the trolling motor mount until equal lengths extend on both sides of the mount. 2 Secure the hose clamp around the trolling motor . NOTE: Do not rotate the transducer. 3 Secure the transducer cable to the motor shaft or other secure location. 4 Route the transducer cable to the installation location of the sonar module while taking these precautions. • You should not route the cable close to electrical wires or other sources of electrical interference. • You must route the cable so it is not pinched when the trolling motor is deployed or stowed. NOTE: If necessary, for extra cable length you can connect an optional extension cable, available at buy.garmin.com or from your Garmin dealer. 5 Position the transducer to your desired angle (Trolling Motor Mount Orientation, page 5). 4