Garmin LiveScope LVS32-IF Installation Instructions - Page 9

Mounting the GLS 10 Black Box Device

Get Garmin LiveScope LVS32-IF PDF manuals and user guides View all Garmin LiveScope LVS32-IF manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

Mounting the GLS 10 Black Box Device NOTICE If you are mounting the device in fiberglass, when drilling the pilot holes, use a countersink bit to drill a clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer when the screws are tightened. NOTE: Screws are included with the device, but they may not be suitable for the mounting surface. Before you mount the device, you must select a mounting location, and determine what screws and other mounting hardware are needed for the surface. 1 Place the black box device in the mounting location, and mark the location of the pilot holes. 2 Drill a pilot hole for one corner of the device. 3 Loosely fasten the device to the mounting surface with one corner, and examine the other three pilot-hole marks. 4 Mark new pilot-hole locations if necessary, and remove the device from the mounting surface. 5 Drill the remaining pilot holes. 6 Secure the device to the mounting location. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
Mounting the GLS 10 Black Box Device
NOTICE
If you are mounting the device in fiberglass, when drilling the pilot holes, use a countersink bit to drill a
clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer
when the screws are tightened.
NOTE:
Screws are included with the device, but they may not be suitable for the mounting surface.
Before you mount the device, you must select a mounting location, and determine what screws and other
mounting hardware are needed for the surface.
1
Place the black box device in the mounting location, and mark the location of the pilot holes.
2
Drill a pilot hole for one corner of the device.
3
Loosely fasten the device to the mounting surface with one corner, and examine the other three pilot-hole
marks.
4
Mark new pilot-hole locations if necessary, and remove the device from the mounting surface.
5
Drill the remaining pilot holes.
6
Secure the device to the mounting location.
9