Garmin LiveScope LVS32-IF Installation Instructions - Page 7

Installing the Transducer on a Transom

Get Garmin LiveScope LVS32-IF PDF manuals and user guides View all Garmin LiveScope LVS32-IF manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Trolling Motor Shaft Orientation The angle of installation depends on the side of the trolling motor shaft you mount the bracket on, and your desired field of view. TIP: No tools are necessary to change the orientation from forward to down. Turn the mount one click to change the orientation from forward to down. Port side, forward view Port side, downward view Starboard side, forward view Starboard side, downward view Installing the Transducer on a Transom Optional Spray Shield Accessory If necessary, to reduce spray from the transducer, you can install an optional spray shield (010-12406-00). Go to buy.garmin.com or contact your Garmin dealer for information. Assembling the Transom-Mount Hardware 1 Attach the transducer mount bracket to the transducer washers . using the mounting screws and lock 2 Attach the transducer mount bracket to the transom mount bracket using the bolts , flat washers , and lock nuts . NOTE: The recommended torque applied to the bolts is 15 lb-ft. (20 N-m). 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
Trolling Motor
Shaft
Orientation
The angle of installation depends on the side of the trolling motor shaft you mount the bracket on, and your
desired field of view.
TIP:
No tools are necessary to change the orientation from forward to down. Turn the mount one click to
change the orientation from forward to down.
Port side, forward view
Port side, downward view
Starboard side, forward view
Starboard side, downward view
Installing the Transducer on a Transom
Optional Spray Shield Accessory
If necessary, to reduce spray from the transducer, you can install an optional spray shield (010-12406-00). Go
to
buy.garmin.com
or contact your Garmin dealer for information.
Assembling the Transom-Mount Hardware
1
Attach the transducer mount bracket
to the transducer
using the mounting screws
and lock
washers
.
2
Attach the transducer mount bracket to the transom mount bracket
using the bolts
, flat washers
,
and lock nuts
.
NOTE:
The recommended torque applied to the bolts is 15 lb-ft. (20 N-m).
7