Garmin Oregon 200 Owner's Manual - Page 49

Attaching the Carabiner, Calibrating the Touchscreen, normally require calibration. - instructions

Get Garmin Oregon 200 - Hiking GPS Receiver PDF manuals and user guides
UPC - 753759078553
View all Garmin Oregon 200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

Attaching the Carabiner A carabiner with a clip comes with the Oregon 300 and 400 series units and is optional with 200 series units. 1. Position the carabiner clip in the slots on the mounting spine of the Oregon. Carabiner Mounting spine Carabiner clip Appendix To remove the carabiner clip, lift the bottom of the clip and slide the carabiner clip off the mounting spine. Calibrating the Touchscreen The Oregon screen does not normally require calibration. However, if the buttons do not seem to be responding properly, use the following process. To calibrate the touchscreen: 1. While the unit is turned off, press and hold the Power key for approximately 30 seconds. 2. Follow the instructions on the screen until "Calibration is complete" is displayed. 2. Slide the clip up until it locks in place. Oregon Series Owner's Manual 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
Oregon Series Owner’s Manual
´±
Appendix
Attaching the Carabiner
A carabiner with a clip comes with
the Oregon 300 and 400 series units
and is optional with 200 series units.
1. Position the carabiner clip in the
slots on the mounting spine of the
Oregon.
Carabiner clip
Carabiner
Mounting spine
2. Slide the clip up until it locks in
place.
To remove the carabiner clip, lift
the bottom of the clip and slide the
carabiner clip off the mounting spine.
Calibrating the
Touchscreen
The Oregon screen does not
normally require calibration.
However, if the buttons do not seem
to be responding properly, use the
following process.
To calibrate the touchscreen:
1. While the unit is turned off, press
and hold the
Power
key for
approximately 30 seconds.
2. Follow the instructions on the
screen until “Calibration is
complete” is displayed.