Garmin zumo 395LM Owners Manual - Page 5
Mounting Your Device in a Motorcycle - cradle
View all Garmin zumo 395LM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installation Mounting Your Device in a Motorcycle Powered Motorcycle Mount WARNING Garmin® strongly recommends having an experienced installer with the proper knowledge of electrical systems install the device. Incorrectly wiring the power cable can result in damage to the vehicle or the battery and can cause bodily injury. See the Important Safety and Product Information guide in the product box for product warnings and other important information. The device must be mounted in a suitable and secure location on your motorcycle, based on available power sources and safe cable routing. NOTE: Both 1/4 in. standard and M6 bolts are included. Match the size of the factory bolts on your clutch-clamp or brake-clamp bracket. 2 Thread the new bolts through the handlebar base, spacers Á , and clutch-clamp or brake-clamp bracket.  3 Tighten the bolts to secure the base. Attaching the Power Cables to the Motorcycle Mount 1 Thread the power cable connector through the top of the À opening in the motorcycle mount. Motorcycle cradle À 12 to 24 Vdc system power (red) with in-line fuse Á System ground (black)  Installing the Handlebar Base The device includes parts for two handlebar installation solutions. Custom mounts may require additional hardware. Installing the U-bolt and Handlebar Base 1 Place the U-bolt around the handlebar , and thread the À Á ends through the handlebar base .  2 Slide the cable down to the bottom of the opening and pull Á the cable back until it is snug. 3 Screw the black screw into the back of the mount to  à hold the cable in place. 2 Tighten the nuts to secure the base. NOTE: The recommended torque is 50 lbf-in (5.65 N-m). Do not exceed torque of 80 lbf-in (9.04 N-m). Installing the Handlebar Base to the Clutch-Clamp or BrakeClamp Brackets 1 Remove the two factory bolts on your clutch-clamp or brake- clamp bracket . À 4 Thread the weather cap through the top hole and press it Ä into the hole. Installation 1