GE GFDR485GFRR Installation Instructions - Page 32
REVERSING THE DOOR SWING if desired, Installation Instructions
View all GE GFDR485GFRR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Installation Instructions REVERSING THE DOOR SWING (if desired) 1 REMOVE THE DOOR ASSEMBLY A. Open the door to fully. B. Remove 2 screws (#10 x 5/8") from the hinge, starting with the bottom screw. The door will tilt away from the front panel, but will come to rest in place. 3 DISASSEMBLE THE DOOR ASSEMBLY A. Place door on a soft and flat surface with the inner door frame facing upward. B. Remove 10 screws (#8 x 7/8") from the perimeter of the door frame. C. Separate the inner door frame from the chrome door cover. Set the inner door frame aside on a soft and flat surface. C. Lift the door slightly and unhook if from the front panel. D. Place the door on a soft and flat surface. 2 RE-LOCATE THE HINGE STRIKER AND FRONT PANEL PLUGS IMPORTANT: Note the location of the hinge (left or right) before removing. A. Remove 2 screws (#10 x 5/8") and front panel plugs from the front panel. B. Re-install front panel plugs and screws on opposite side of the door opening. C. Remove 2 screws (#8 x 1/2") and hinge striker from the front panel. D. Rotate hinge striker 180 degrees and re-install with screws on the opposite side of the door opening. 4 RE-LOCATE THE DOOR MASK A. Place the chrome door cover on a soft and flat surface so that the door mask is facing upwards. B. Remove 2 screws (#8 x 1/2") that secure the door mask in place. C. Rotate the door mask 180 degrees and re-install screws to secure door mask. BEFORE AFTER D. Re-location is complete. Set chrome door cover aside. 32