Haier HL26K1 User Manual - Page 12

External Equipment Connections Installation Connecting a DTV(digital TV) This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below. This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i). ANT IN HDMI IN VIDEO IN COMPONENT IN OPTICAL OUT How to connect Use the TV`s COMPONENT , VGA or HDMI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections. How to use 1. Turn on the digital set-top box. (Refer to the owner`s manual for the digital set-top box.) 2. Use INPUT on the remote control to select COMPONENT , VGA or HDMI source. 2 L 2 DVI AUDIO 1 R 1 Y 1 Pb Pr L AUDIO R VGA AUDIO VGA AV OUT VGA IN Signal 480i 480p 720p 1080i 1080p COMPONENT Yes Yes Yes Yes Yes HDMI Yes Yes Yes Yes Yes VIDEO L AUDIO R S-VIDEO L AUDIO R VIDEO L AUDIO R ANT IN HDMI IN Connecting a digital audio output Send the TV`s audio to external audio equipment (stereo system) via the Digital Audio Output (Optical) port. How to connect 1. Connect one end of an optical cable to the TV Digital Audio(Optical) Output port. 2. Connect the other end of the optical cable to the digital audio (optical) input on the audio equipment. See the external audio equipment instruction manual for operation. Note When connecting with external audio equipments, such as amplifers or speakers, please turn the TV speakers off. Caution: Do not look into the optical output ! port. Looking at the laser beam may damage your vision. VIDEO IN COMPONENT IN OPTICAL OUT HDMI Digital Set-top Box 2 L 2 DVI AUDIO 1 R 1 Y 1 Pb Pr L AUDIO R VGA AUDIO VGA VIDEO L AUDIO R S-VIDEO L AUDIO R VIDEO L AUDIO R AV OUT VGA IN 12 TV LCD-TFT