Haier HWM65-728 User Manual - Page 14

Clean the detergent box with water(applicable for the model HWM60-728): The method of dismantlement and installation refer to the usage of the lint filter B. Install Dismantle Detergent box Cleaning the lint ¿lter A(applicable for the model HWM65-728) and the lint filter B(applicable for the model HWM60-728): 1 Push down the spring piece at the top of the lint ¿lter to make the claws out of the ¿lter cover, and then pull out the lint ¿lter to get it down.(figure 1) 2 Pull the back cover of the lint ¿lter, and then you can get down it off the front cover of the lint ¿lter.(figure 2) Sweep the rubbish in the lint ¿lter.Put the back cover of the lint ¿lter into the front cover . 3 Put the lint ¿lter into ¿lter cover, and make it tight . 4 Make sure the lint ¿lter well installed, or it can inÀuence your use. Filter cover Lint filter A Filter cover The front cover Install of lint filter Figure 1 Figure 2 Install Dismantle Lint filter B Figure 1 Dismantle The back cover of lint filter Figure 2 The lint filter must be used during washing. It must be cleaned in time after each using. Notes: z The ¿lter screen of the water inlet valve is likely to be blocked by foreign materials and inÀuence the water inlet. Please clean it with brush every two months. z If the cabinet is dirty, wipe it with wet cloth z Do not Àush it directly with water. z Wipe it with neutral detergent. z Do not wipe it with thinner, petrol, alcohol etc. z After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose). z Do not store water in the washing machine for a long period. Drain the water completely after each using. z Be sure to pull off the power plug before maintenance. z Hang up the power cord and drain hose. z Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time ( about 1 hour), then close the top lid. 14