Haier HWM65-728 User Manual - Page 8

How to change the direction of the drain hose 1.Dismantle the back cover of the washing machine. 2.Take off the drain hose frame. Put down the drain hose , put the drain hose into the cabinet, take off the drain hose bushing(As indicated in Figure 1). 3.Dismantle the protecting cover of the drain outlet at the other side.Install the drain hose bushing (As Indicated in Figure 2). 4.Extend the drain hose from the other side. Fixthe drain hose with the drain hose frame(As indicated in Figure 3). Drain hose Drain hose bushing frame Figure 1 Drain hose frame Drain outlet Drain hose protecting cover bushing Figure 2 Drain outlet protecting cover Drain hose 5.Install the protecting cover of the drain outlet at the other side (As indicated in Figure 4). Figure 3 Figure 4 Remark:In order to make sure of the correct of installation, it is suggested to change the direction of the drain hose with our company serviceman. The drain hose shall drain smoothly. 1 The height of the drain hose shall be less than 10cm , or the drainage will not be smooth, and cost such long time that the machine may stop at mid way. 2 Do not trample or press the drain hose. 3 If the drain hose is too long, cut it at mid point. To make smooth drainage,cut the front end of the hose slantingly. 4 If extra drain hose is needed,please make separate purchase.The inner diameter of the etxra hose shall not less than 30mm, and the length shall not exceed 1.5m. 5 If the extra hose is too long,cut it either at A or at Bpoint. 8