Haier HWM65-728 User Manual - Page 6
Connection between the water inlet hose jointer and the, water faucet, Confirm the water faucet
View all Haier HWM65-728 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Confirm the water faucet z It is required that the front end shall be longer than 10mm. z The exit end face of the faucet shall be flat and smooth.If not please file it to avoid leakage. water faucet, suitable water faucet, not suitable The exit end face of the faucet Connection between the water inlet hose jointer and the water faucet 1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1. water inlet hose jointer Slider Lock lever water inlet hose Figure 1 2.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet,please loosen the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth, otherwise it may leak water .See to Figure 3.) Screw Sign plate Bushing Screw knife Figure 2 Figure 3 3.Fasten the four screws evenly. See to Figure 4. Figure 4 4.Take off the nameplate. Twist the fastening nut as per the indication of the figure to seal up the exit end face of the faucet. See to Figure 5. Remark: Before installation, the threading is 4mm above the upper surface of the nut.After installation, the threading is 2mm above the upper surface of the nut.See to Figure 6. Screw nut About 4mm before twisting About less than 2mm after twisting Figure 5 Figure 6 6