HP 1606 HP StorageWorks B-series Data Center Fabric Manager Enterprise, Profes - Page 40
Fixed in DCFM 10.4.0., Accept Changes
View all HP 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Closed fixes summary Solution On Editing the view, there is a mismatch between the levels set under the Manage view option in View menu and the levels shown in device tree. Workaround prior to upgrade: Reset the levels under the Manage view option in view menu. Fixed in DCFM 10.4.0. Flyover is not displayed between the created new storage array and switch. Able to create two or more New servers/Storage arrays with same name as a fabric name and error message is not shown. Created storage array entry persists even after the corresponding fabric is unmonitored. Fixed in DCFM 10.4.0. Fixed in DCFM 10.4.0. Workaround prior to upgrade: Close and re-launch the client. Fixed in DCFM 10.4.0. Disconnect button is enabled when there is no selection of active client in Active Session dialog box. If Disconnect is clicked, active client is not removed from the dialog box but actually client is disconnected with no masterlog message. Fixed in DCFM 10.4.0. Active TI zone is shown with green icon in Activate Zone Config dialog box for Fabric OS less than 6.2.0. Fixed in DCFM 10.4.0. Enabling a tunnel failed with the message Tunnel Admin Status cannot be set. error: failed to modify. Fixed in DCFM 10.4.0. Not able to manage the switch in server A although the fabric is unmonitored in server B. Fixed in DCFM 10.4.0. Fabric changes cannot be accepted due to Access Gateway collector run before switch creation. When an Access Gateway-capable device newly joins the fabric, the device type is not updated with an Access Gateway icon in the Connectivity Map and user will not be able to perform the "Accept Changes" operation. Fixed in DCFM 10.4.0. Fabric port report is not showing the details in fabric section in Linux OS. Fixed in DCFM 10.4.0. Switch Model Number is always shown as Brocade 200e in Email Call Home Content when switch is in AG Mode, regardless of the switch model. Fixed in DCFM 10.4.0. Active zone Configuration is not getting updated when the zone is enabled from CLI for the Fabric OS 6.1.2 seed switch. Workaround prior to upgrade: Rediscover the fabric. Fixed in DCFM 10.4.0. Event description is not available in Call home centers. Edge fabric is not shown in LSAN Zoning dialog box. Fixed in DCFM 10.4.0. Workaround prior to upgrade: Delete the unmonitored fabric and reopen the LSAN Zoning dialog box. Fixed in DCFM 10.4.0. 40