HP 203039-B21 Console Management Controller User Guide - Page 27
Intrusion Sensor, Make sure the magnet and switch align with each other and allow
UPC - 720591484798
View all HP 203039-B21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Installation 2-9 Intrusion Sensor Intrusion Sensor An intrusion sensor consists of two parts: A magnet An electrical switch 1. The magnet should be installed on the inside of the rack door and the electrical switch on the rack as shown in the following instructions. Make sure the magnet and switch align with each other and allow sufficient clearance for the doors to close. 2. The intrusion sensors should be installed on the front door of the rack, as well as the rear door . 1 2 Figure 2-5. Installing the intrusion sensor in the 9000 series rack
Installation
2-9
Intrusion Sensor
Intrusion Sensor
An intrusion sensor consists of two parts:
■
A magnet
■
An electrical switch
1.
The magnet should be installed on the inside of the rack door and the
electrical switch on the rack as shown in the following instructions.
Make sure the magnet and switch align with each other and allow
sufficient clearance for the doors to close.
2.
The intrusion sensors should be installed on the front door
of the rack,
as well as the rear door
.
1
2
Figure 2-5.
Installing the intrusion sensor in the 9000 series rack