HP 203039-B21 Console Management Controller User Guide - Page 32
Smoke sensor kit, Add couplings and tubes until the tube reaches the bottom of
UPC - 720591484798
View all HP 203039-B21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
2-14 Compaq Console Management Controller User Guide Smoke sensor kit Install the optional smoke sensor as follows: a. Place the smoke sensor on rear rack door. Then place the screws with washers through the holes in the door and secure the sensor. IMPORTANT: For the smoke sensor to be effective, the sampling tube must be placed in the path of the exhaust air from the equipment within the rack. b. Install a tube coupling on a section of the sampling tube. Insert the coupling into the smoke sensor. Position the holes in the tube to face the equipment in the rack. Hand-tighten the connection of the coupling and smoke sensor. c. Add couplings and tubes until the tube reaches the bottom of the door. d. Insert the plastic end cap on the bottom of the tube to secure the bracket to the end of the tube . e. Align the bottom tube vertically with the sensor . f. Insert a screw (with washer) through the hole in the door and fasten it to the tube bracket using a nut. 2 1 4 3 Figure 2-12. Installing the smoke sensor