HP 2120 HP StorageWorks Disk System 2120 Users Guide (5697-5367, March 2005) - Page 10
SCSI ID Switch, disk modules are 9
View all HP 2120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 HP StorageWorks Disk System 2120 SCSI ID Switch The SCSI ID switch sets the address for the disk drives. There are three possible settings for the SCSI address switch: A, B, and C. Each setting assigns a different set of addresses to the disk modules installed in the disk system. For SCSI address switch setting A, the addresses for the installed disk modules are (from left to right, looking at the disk system from the front) 0, 2, 4, and 6. For SCSI address switch setting B, the addresses for the installed disk modules are 8, 10, 12, and 14. For SCSI address switch setting C, the addresses for the installed disk modules are 9, 11, 13, and 15. See Figure 5, below. SCSI address 7 is reserved for use by the host bus adapter. FIGURE 5 SCSI ID Switch Settings C B A SCSI Address Switch Setting A B C Disk Module SCSI Addresses (Viewed from front of storage enclosure) 0 2 4 6 8 10 12 14 9 11 13 15 Note The disk system requires a terminator when it is installed at the end of the SCSI bus.