HP 220mx HP SureStore 9100mx Optical Disk Drive User's Guide - Page 17
Rear Panel Features
View all HP 220mx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Chapter 1: Setting upSethtteinDgiuskp Dthreive Disk Drive Setting up the Disk Drive Rear Panel Features The following numbers correspond to the numbers in the drawing on the previous page. 1 SCSI ID switch Used to set the SCSI ID. Refer to "Setting the SCSI ID" in this section. 2 Operation mode switch Used to choose the operating mode and set your preference for write verify. Refer to "Setting the Operation Mode" in this section. 3 Power connector Receptacle for the power cord. 4 On/Off switch Used to switch power on or off. 5 SCSI connector (with terminator attached) 50-pin high-density SCSI connector (Micro D-type). Terminator may be attached to either connector (see "6"). A terminator must be plugged into either "5" or "6" when the drive is the last physical device on a SCSI bus. 6 SCSI connector (with cable attached) 50-pin high-density SCSI connector (Micro D-type). Cable may be attached to either connector (see "5"). A terminator must be plugged into either "5" or "6" when the drive is the last physical device on a SCSI bus. Chapter 1 1- 5