HP 3PAR StoreServ 7200 2-node HP 3PAR Management Console 4.3.1 User's - Page 193
Links, Groups, Select 1
View all HP 3PAR StoreServ 7200 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 193 highlights
At this point, if you reassign a system to one that runs a non-supported HP 3PAR OS, the Additional Targets for Multimode will be deselected and disabled, and the additional target pair will be removed. 6. Click Next. Links 1. A graphical representation of each system's Remote Copy ports appears under Create Links Between Systems. Click and drag from one port on one system to a port on the other system. Repeat for a second port. 2. For IP links, in the IP Settings groups for each system/port, all fields are automatically populated based on the link relationship you established under Create Links Between Systems. a. (Optional) Enter the gateway address for each system/port. b. (Optional) Click Apply to test the link configuration, or Ping to test the communication between the links. 3. For Fibre Channel links, in the Settings groups for each system/port: a. Connection Type - Select Point for point-to-point mode or Loop for arbitrated loop mode. b. Configured Rate - Select 1, 2, 4 Gbps, or Auto (default). c. Click Apply to test the link configuration, or Ping to test the communication between the links. 4. Click Next. NOTE: If Fibre Channel ports are not displayed, the ports may not be zoned correctly, or may not be physically connected. See Configuring Fibre Channel Ports for RCFC for additional information. Groups 1. 2. 3. 4. In the Source group: a. System - Select the system on which the Remote Copy group will reside. b. (Optional) Domain - Select the domain in which the Remote Copy group will reside. c. Group - Enter a name for the Remote Copy group. d. (Optional) Start group after completion - Select if you want the Remote Copy group to be started (start mirroring) after it is created. e. (Optional) Do not perform initial sync - Select if you do not want the created Remote Copy group to be synchronized with its backup group. Before selecting this option verify both sides are synchronized or it may lead to data inconsistency. (This option is available if Show tape backup options in Remote Copy wizards was selected in the Preferences.) In the Backup group: a. Name - The system NOT selected as the source system, automatically appears. b. Mode - Select Synchronous or Periodic. c. Sync Period - If you selected Periodic, select second(s), minute(s), hour(s), or day(s) and enter a numeric value for when you wish the source and backup groups to synchronize. d. (Optional) Auto Recover - Select if you want the group to be restarted automatically after Remote Copy links come back up should the links go down. (Displayed only if Show advanced options is selected.) e. (Optional) Over Period Alert - Select if you want an alert to be generated if the synchronization of a periodic group takes longer than its set synchronization period. This option is not available for groups in synchronous mode. (Displayed only if Show advanced options is selected.) Click Add. (Optional) Repeat steps 1 through 3 to create additional Remote Copy groups. Configuring Remote Copy 193