HP 3PAR StoreServ 7200 2-node HP 3PAR Management Console 4.3.1 User's - Page 44
SFP Tab, Displays whether the SFP is DDM-capable Digital Diagnostic
View all HP 3PAR StoreServ 7200 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Group Field Mode Change Link State Persona (not displayed on systems using HP 3PAR OS 2.3.1 or higher) Persona Vendor Adapter Type OS Connection Modified Description Indicates whether port mode change from initiator to target or vice versa is Allowed or Prohibited. This setting is configured using the HP 3PAR CLI command controlport. The state of the link. Number for the current port persona setting. Manufacturer of the host computers network adapter. This value is determined by the port persona. Host computer's network adapter. This value is determined by the port persona. Host computers operating system. This value is determined by the port persona. Indicates whether the connection is Direct Connect or Fabric Attached, as determined by the port persona. When a persona has been edited by a user, Modified appears in this column. Otherwise, this column remains blank (--). SFP Tab The RCFC SFP information is presented on the SFP tab. The following information is provided: Group General DDM Field Position State Manufacturer Part Number Serial Number Revision Max Speed Qualified TX Disable TX Fault RX Loss RX Power Low DDM Support Type Unit Value Low Threshold Warning High Threshold Warning Description The location of the SFP within the system. Current condition of the SFP. Manufacturer of the SFP. Part number of the SFP. Serial number of the SFP. SFP's revision level. Maximum speed allowed by the SFP. Displays whether the SFP has been tested and if the SFP is supported. Displays whether the transmit laser is disabled. Displays whether the transmit laser has a problem. Displays whether the receive end of the SFP is experiencing a loss of signal from the host or drive cage. Displays whether the SFP receive power is low. Displays whether the SFP is DDM-capable (Digital Diagnostic Monitoring). Identifies the monitored parameters (temperature, voltage, TX bias, TX power, and RX power). The unit of measure used for the monitored parameters. The current measured value. The manufacturer's recommended lower-limit warning level. The manufacturer's recommended upper-limit warning level. 44 Managing Ports