HP 60 HP StorageWorks 60 Modular Smart Array Enclosure Maintenance and Service - Page 32
Remove the I/O module
View all HP 60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Before replacing the component, verify component failure using the following methods: • Check the hard drive status LEDs. Test with known good hard drives. • Check the host log for errors. To remove the components: 1. Power down the storage enclosure (on page 19). 2. Remove all hot-plug hard drives ("Hot-plug SAS or SATA hard drive" on page 20). 3. Remove the power supplies ("Hot-plug power supply" on page 22). 4. Remove the system fans ("Hot-plug fan" on page 23). 5. Remove the I/O module ("I/O module" on page 24). 6. Remove the I/O module blank ("I/O module" on page 24). 7. Remove the storage enclosure (on page 19). 8. Remove the access panel ("Access panel" on page 20). 9. Remove the 7-segment display board ("7-segment display board" on page 28). 10. Remove the riser board ("Riser board" on page 29). 11. Remove the midplane ("Midplane" on page 30). 12. Remove the screw (1). 13. Tilt the backplane up from the bottom and lift out of the chassis (2). To replace the components, reverse the removal procedure. Verifying proper operation After replacing the component, check the hard drive status LEDs. Removal and replacement procedures 32