HP Cisco MDS 9020 Cisco MDS 9000 Family Storage Media Encryption Configuration - Page 219

Appendix A Cisco SME CLI Commands show fc-redirect active-configs Send documentation comments to [email protected] show fc-redirect active-configs To display all active configurations on a switch, use the show fc-redirect active-configs command. show fc-redirect active-configs Syntax Description This command has no arguments or keywords. Defaults None. Command Modes EXEC mode. Command History Release 3.2(2c) Modification This command was introduced. Usage Guidelines This command is used to verify if there are active configurations running on the switch during the following procedures: • Downgrading from a Cisco SAN-OS 3.2(1) image (supporting FC-Redirect) to an older image where FC-Redirect is not supported. • Decommissioning a local switch. Note Active configuration implies configurations created by applications running on the current switch or applications created on remote switches, except the targets and hosts connected to the local switch. Examples The following example displays the active configurations running on the switch: switch# show fc-redirect active-configs Config#1 ========== Appl UUID = 0x00D8 (ISAPI CFGD Service) SSM Slot = 2 SSM Switch WWN = 20:00:00:05:30:00:90:9e (LOCAL) Vt PWWN = 2f:ea:00:05:30:00:71:64 Tgt PWWN = 21:00:00:20:37:38:63:9e (LOCAL) Local Host PWWN = 21:00:00:e0:8B:0d:12:c6 Config#2 ========== Appl UUID = 0x00D8 (ISAPI CFGD Service) SSM Slot = 2 SSM Switch WWN = 20:00:00:05:30:00:90:9e (LOCAL) Vt PWWN = 2f:ea:00:05:30:00:71:65 Tgt PWWN = 21:00:00:20:37:18:67:2c Local Host PWWN = 21:00:00:e0:8B:0d:12:c6 Config#3 OL-18091-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Storage Media Encryption Configuration Guide A-31