HP Cisco MDS 9124 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 1164

Configuring RMON Using Threshold Manager Chapter 61 Configuring RMON Send documentation comments to [email protected] Enabling RMON Alarms for Physical Components To configure an RMON alarm for a physical component using Device Manager, follow these steps: Step 1 Choose Admin > Events > Threshold Manager and click the Physical tab. You see the Threshold Manager dialog box with the Physical tab selected (see Figure 61-4). Figure 61-4 Threshold Manager Physical Tab Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step 8 Check the check box in the Select column for each variable to monitor. Enter the threshold value in the Value column. Enter the sampling period in seconds. Choose one of the following severity levels to assign to the alarm: Fatal(1), Warning(2), Critical(3), Error(4), Information(5). Click Create. Confirm the operation to define an alarm and a log event when the system prompts you to define a severity event. If you do not confirm the operation, the system only defines a log event. Click More, then click the Alarms tab in the Threshold Manager dialog box to verify the alarm you created (see Figure 61-5). Figure 61-5 List of Threshold Alarms Step 9 Close both dialog boxes. 61-6 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x