HP Cisco MDS 9124 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 613

Chapter 30 Configuring and Managing Zones Advanced Zone Attributes Send documentation comments to [email protected] Step 5 Click OK to save these changes. Configuring the Default Zone Policy To permit or deny traffic in the default zone using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Choose Zone > Edit Local Full Zone Database. You see the Select VSAN dialog box. Select a VSAN and click OK. You see the Edit Local Full Zone Database dialog box for the selected VSAN. Choose Edit > Edit Default Zone Attributes to configure the default zone QoS priority attributes. You see the Modify Default Zone Properties dialog box shown in Figure 30-34. Figure 30-34 Modify Default Zone Properties Dialog Box Step 4 Step 5 Set the Policy drop-down menu to permit to permit traffic in the default zone, or set it to deny to block traffic in the default zone. Click OK to save these changes. About Broadcast Zoning Note Broadcast zoning is not supported on the Cisco Fabric Switch for HP c-Class BladeSystem and the Cisco Fabric Switch for IBM BladeCenter. You can configure broadcast frames in the basic zoning mode. By default, broadcast zoning is disabled and broadcast frames are sent to all Nx ports in the VSAN. When enabled, broadcast frames are only sent to Nx ports in the same zone, or zones, as the sender. Enable broadcast zoning when a host or storage device uses this feature. Table 30-2 identifies the rules for the delivery of broadcast frames. OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 30-35