HP Cisco MDS 9134 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 237
speed (Ethernet
View all HP Cisco MDS 9134 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 237 highlights
Chapter 2 Ethernet Commands speed (Ethernet) Send comments to [email protected] speed (Ethernet) To configure the transmit and receive speed for an Ethernet interface, use the speed command. To reset to the default speed, use the no form of this command. speed {1000 | 10000} no speed Syntax Description 1000 10000 Sets the interface speed to 1-Gigabit. Sets the interface speed to 10-Gigabit. This is the default speed. Command Default The default speed is 10000 (10-Gigabit) Command Modes Interface configuration mode Command History Release 4.0(1a)N1(1) Modification This command was introduced. Usage Guidelines The first 8 ports of a Nexus 5010 switch and the first 16 ports of a Nexus 5020 switch are switchable 1-Gigabit and 10-Gigabit ports. The default interface speed is 10-Gigabit. To configure these ports for 1-Gigabit Ethernet, insert a 1-Gigabit Ethernet SFP transceiver into the applicable port and then set its speed with the speed command. Note If the interface and transceiver speed is mismatched, the SFP validation failed message is displayed when you enter the show interface ethernet slot/port command. For example, if you insert a 1-Gigabit SFP transceiver into a port without configuring the speed 1000 command, you will get this error. By default, all ports on a Cisco Nexus 5000 Series switch are 10 Gigabits. Examples The following example shows how to to set the speed for a 1-Gigabit Ethernet port: switch# configure terminal switch(config)# interface ethernet 1/1 switch(config-if)# speed 1000 Related Commands Command show interface Description Displays the interface configuration information. OL-16599-01 Cisco Nexus 5000 Series Command Reference 2-89