HP Cisco MDS 9134 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 683
zone default-zone, system default zone
View all HP Cisco MDS 9134 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 683 highlights
Chapter 8 Fibre Channel Commands zone default-zone Send comments to [email protected] zone default-zone To define whether a default zone (assigned to nodes not assigned to a created zone) permits or denies access to all nodes in the default zone, use the zone default-zone command. Use the no form of the command to negate the command or revert to the factory defaults. zone default-zone permit vsan vsan-id no zone default-zone permit vsan vsan-id Syntax Description permit vsan vsan-id Permits access to all nodes in the default zone. Sets default zoning behavior for the specified VSAN. The ID of the VSAN is from 1 to 4093. Command Default All default zones are permitted access. Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines Use the zone default-zone permit vsan command to define the operational values for the default zone in a VSAN. This command applies to existing VSANs; it has no effect on VSANs that have not yet been created. Use the system default zone default-zone permit command to use the default values defined for the default zone for all VSANs. The default values are used when you initially create a VSAN and it becomes active. Examples The following example permits default zoning in VSAN 2: switch(config)# zone default-zone permit vsan 2 Related Commands Command system default zone default-zone permit show zone Description Configures default values for a zone. Displays zone information. OL-16599-01 Cisco Nexus 5000 Series Command Reference 8-149