HP Cisco MDS 9140 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 228
spanning-tree port type edge default, Cisco Nexus 5000 Series Command Reference, OL-16599-01
View all HP Cisco MDS 9140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 228 highlights
spanning-tree port type edge default Chapter 2 Ethernet Commands Send comments to [email protected] spanning-tree port type edge default To configure all access ports that are connected to hosts as edge ports by default, use the spanning-tree port type edge default command. To restore all ports connected to hosts as normal spanning tree ports by default, use the no form of this command. spanning-tree port type edge default no spanning-tree port type edge default Syntax Description This command has no arguments or keywords. Command Default Disabled. Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines Use this command to automatically configure all interfaces as spanning tree edge ports by default. This command will not work on trunk ports. Caution Be careful when using this command. You should use this command only with interfaces that connect to end stations; otherwise, an accidental topology loop could cause a data-packet loop and disrupt the switch and network operation. When a linkup occurs, an interface configured as an edge port automatically moves the interface directly to the spanning tree forwarding state without waiting for the standard forward-time delay. (This transition was previously configured as the Cisco-proprietary PortFast feature.) When you use this command, the system returns a message similar to the following: Warning: this command enables portfast by default on all interfaces. You should now disable portfast explicitly on switched ports leading to hubs, switches and bridges as they may create temporary bridging loops. You can configure individual interfaces as edge ports using the spanning-tree port type edge command. The default spanning tree port type is normal. Examples This example shows how to globally configure all ports connected to hosts as spanning tree edge ports: switch(config)# spanning-tree port type edge default 2-80 Cisco Nexus 5000 Series Command Reference OL-16599-01