HP Cisco MDS 9140 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 620

fspf hello-interval Chapter 8 Fibre Channel Commands Send comments to [email protected] fspf hello-interval To verify the health of the link, use the fspf hello-interval command. To revert to the default value, use the no form of the command. fspf hello-interval seconds vsan vsan-id no fspf hello-interval seconds vsan vsan-id Syntax Description hello-interval seconds Specifies the FSPF hello-interval in seconds. The range is 2 to 65535. vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093. Command Default 20 seconds. Command Modes Interface configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines This command is not applicable to virtual Fibre Channel interfaces. This command configures FSPF for the specified Fibre Channel interface. This value must be the same in the ports at both ends of the ISL. Examples The following example configures a hello interval of 3 seconds on VSAN 1: switch(config)# interface fc 2/1 switch(config-if)# fspf hello-interval 3 vsan 1 Related Commands Command show fspf interface Description Displays information for each selected interface. 8-86 Cisco Nexus 5000 Series Command Reference OL-16599-01