HP Cisco MDS 9216 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 480
VRRP_ENG-3, show interface, shutdown, show process
View all HP Cisco MDS 9216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 480 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message VRRP_ENG-2-INVALID_CONFIG: Cannot start the VR [dec] on the interface [chars]. Invalid IP configuration. Reason: [chars]. Explanation The specified virtual router on the interface is enabled, but the IP configuration is not valid because of the error shown in the error message. Recommended Action Enter the show interface CLI command or use a similar Fabric Manager/Device Manager procedure to ensure the IP address of the interface is configured and is in the same subnet of the virtual router address. Introduced Cisco MDS SAN-OS Release 1.2(2a). VRRP_ENG-3 Error Message VRRP_ENG-2-VR_FAILURE: Error in VR[chars] [dec] interface [chars]. Going to init state. Explanation The virtual router on the interface is in the initialization state because of an internal error. Recommended Action Enter the show interface CLI command or use a similar Fabric Manager/Device Manager procedure to check the status of the interface. Check the configuration, status, and statistics of the specified virtual router and enable VRRP debug for further information. Enter shutdown and no shutdown on the specified virtual router. Introduced Cisco MDS SAN-OS Release 1.2(2a). VRRP_ENG-4 Error Message VRRP_ENG-3-INIT_FAILED: Initialization failed. Component [chars]. Explanation The service failed to start. The failure occurred while initializing the component shown in the error message. Recommended Action Enter the show process CLI command or use a similar Fabric Manager/Device Manager procedure to check the status of the other processes and debug the specified component. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message VRRP_ENG-4-BAD_ADV: VR[chars] ID [dec] on interface [chars] bad advertisement received: reason [chars]. Explanation The virtual router specified has received an invalid advertisement. Recommended Action Check that all VRRP nodes have the same configuration. Introduced Cisco MDS SAN-OS Release 3.0(1). 2-444 Cisco MDS 9000 Family System Messages Reference OL-15956-01