HP Cisco Nexus 5000 Cisco Nexus 5000 Series Switch CLI Software Configuration - Page 528

Zone Sets Chapter 38 Configuring and Managing Zones Send feedback to [email protected] FC ID example: switch(config-fcalias)# member fcid 0x222222 Domain ID example: switch(config-fcalias)# member domain-id 2 portnumber 23 Local sWWN interface example: switch(config-fcalias)# member interface fc 2/1 Remote sWWN interface example: switch(config-fcalias)# member interface fc 2/1 swwn 20:00:00:05:30:00:4a:de Domain ID interface example: switch(config-fcalias)# member interface fc2/1 domain-id 25 Device alias example: switch(config-fcalias)# member device-alias devName Creating Zone Sets and Adding Member Zones To create a zone set to include several zones, perform this task: Step 1 Step 2 Step 3 Step 4 Step 5 Command Purpose switch# configuration terminal Enters configuration mode. switch(config)# zoneset name zoneset-name vsan vsan-id Configures a zone set called Zoneset1. Tip To activate a zone set, you must first create the zone and a zone set. switch(config-zoneset)# member name Adds Zone1 as a member of the specified zone set (Zoneset1). Tip If the specified zone name was not previously configured, this command will return a "zone not present" error message: switch(config-zoneset)# zone name zone-name Adds a zone to the specified zone set. Tip Execute this step only if you need to create a zone from a zone set prompt. switch(config-zoneset-zone)# member fcid fcid Adds a new member to the new zone. Tip Execute this step only if you need to add a member to a zone from a zone set prompt. Tip You do not have to copy the running configuration to the startup configuration to store the active zone set. However, you need to copy the running configuration to the startup configuration to explicitly store full zone sets. 38-12 Cisco Nexus 5000 Series Switch CLI Software Configuration Guide OL-16597-01