HP Cisco Nexus 5000 Cisco Nexus 5000 Series Switch CLI Software Configuration - Page 59

Chapter 2 Using the Command-Line Interface Command Scripts Send feedback to [email protected] The following example shows how to display the command aliases defined on the switch: switch# alias CLI alias commands alias :show cli alias gigint :interface gigabitethernet shintbr :show interface brief shfcintup :shintbr | include up | include fc Command Scripts This section includes the following topics: • Executing Commands Specified in a Script, page 2-11 • Using CLI Variables in Scripts, page 2-12 • Setting the Delay Time, page 2-13 Executing Commands Specified in a Script The run-script command executes the commands specified in a file. To use this command, be sure to create the file and specify commands in the required order. Note You cannot create the script file at the switch prompt. You can create the script file on an external machine and copy it to the bootflash: directory. This section assumes that the script file resides in the bootflash: directory. The syntax for this command is run-script filename. This example displays the CLI commands specified in a test file that resides in the bootflash: directory. switch# show file bootflash:testfile configure terminal interface fc 3/1 no shutdown end show interface fc 3/1 This file output is in response to the run-script command executing the contents in the test file: switch# run-script bootflash:testfile 'configure terminal' Enter configuration commands, one per line. End with CNTL/Z. 'interface fc 3/1' 'no shutdown' 'end' 'show interface fc 3/1' fc3/1 is trunking Hardware is Fibre Channel, SFP is short wave laser w/o OFC (SN) Port WWN is 20:81:00:0d:ec:6b:cd:c0 Peer port WWN is 20:01:00:0d:ec:0d:d0:00 Admin port mode is auto, trunk mode is on snmp link state traps are enabled Port mode is TE Port vsan is 1 Speed is 2 Gbps OL-16597-01 Cisco Nexus 5000 Series Switch CLI Software Configuration Guide 2-11