HP Color LaserJet CM1312 Service Manual - Page 132
Paper-feed assemblies, Pickup roller (product base
View all HP Color LaserJet CM1312 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Paper-feed assemblies Pickup roller (product base) You might have to rotate the pickup roller to gain access to the roller locking tabs. 1. Rotate the roller to the correct position for removal. a. Press the Setup button. b. Press both the left arrow button and the Cancel button at the same time. c. Press the Setup to return to the main menus. d. Use the arrow buttons to highlight 2ndary Service, and then press OK. e. Use the arrow buttons to highlight Pick roller, and then press OK. f. Press OK again to confirm that you want the pick roller to rotate. g. Turn the product power off, and then remove the power cord and the interface cable. 2. Remove the 150-sheet input tray, and then carefully place the product front-side up. CAUTION: The ADF and scanner cover are not captive and can open suddenly if the product is placed front-side up. Always support the ADF and scanner cover before placing the product frontside up. NOTE: Debris can scratch or damage the back of the product. Before you place the product frontside up, remove any debris from the work surface. If possible, set the product on a clean, dry cloth to prevent scratching and damage. 3. Release two white plastic locking tabs and remove the pickup roller. CAUTION: Do not touch the spongy roller surface unless you are going to replace the roller. Skin oils on the roller can cause paper pickup problems. Figure 6-12 Remove the pickup roller 118 Chapter 6 Removal and replacement ENWW