HP Color LaserJet CM1312 Service Manual - Page 183
Power supply (high-voltage), CAUTION,
View all HP Color LaserJet CM1312 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
Power supply (high-voltage) CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA. Some parts are sensitive to electrostatic discharge (ESD). Look for the ESD reminder when removing product parts. Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, ground yourself by touching the sheet-metal chassis before touching an ESD-sensitive part. 1. Remove the following components: ● Right cover. See Right cover on page 132. ● Left cover. See Left cover on page 135. ● Front-right cover. See Front-right cover on page 137. ● Rear-side cover. See Rear-side cover on page 142. ● Rear-upper cover. See Rear-upper cover on page 143. ● Scanner assembly. See Scanner assembly on page 147. ● Top cover. See Top cover on page 149. 2. Disconnect one FFC (callout 1; J107). Figure 6-94 Remove the power supply (high-voltage; 1 of 7) 1 ENWW Internal assemblies 169