HP Dc7100 Troubleshooting Guide - Page 72
If using Windows 2000 or Windows, XP, change SATA Emulation
UPC - 829160356877
View all HP Dc7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
POST Error Messages Numeric Codes and Text Messages (Continued) Code/Message Probable Cause Recommended Action 1785-Multibay incorrectly installed (for Multibay option on non-USDT systems) 1. Multibay option ribbon cables not seated or improperly attached. 2. Multibay device not properly seated. 3. Multibay diskette present. 1. Ensure the Multibay option is attached as device 0 on the IDE cable. 2. Ensure no other device is attached to the same IDE cable. 3. Ensure both ends of the IDE and Multibay ribbon cables are properly seated. 4. Ensure the Multibay device is fully inserted. 5. Ensure a Multibay diskette is not present (Multibay diskette drives are not supported by the Multibay option). (for integrated Multibay/ USDT systems) 1. Multibay device not properly seated. 2. Multibay riser not properly seated. 1. Ensure the Multibay device is fully inserted. 2. Ensure the Multibay riser is properly seated. 1794-Inaccessible devices attached to SATA 1 and/or SATA 3 A device is attached to SATA 1 and/or SATA 3. Devices attached to these connectors will be inaccessible while "SATA Emulation" is set to "Combined IDE Controller" in Computer Setup. 1. If using Windows 2000 or Windows XP, change "SATA Emulation" to "Separate IDE Controller" in Computer Setup. 2. If not using Windows 2000 or Windows XP, relocate the affected devices to SATA 0 or SATA 2 (if available). 3. Remove the affected devices from SATA 1 and SATA 3. A-10 www.hp.com Troubleshooting Guide