HP DreamColor Z27x User Guide 1 - Page 14

Installing the Stand

Get HP DreamColor Z27x PDF manuals and user guides View all HP DreamColor Z27x manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Installing the Stand CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause nonuniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its normal condition. The monitor uses the HP Quick Release 2 for easy mounting and unmounting of the monitor panel. To mount the panel onto the stand: 1. Lay the monitor panel face down on a flat surface covered by a clean, dry cloth. 2. Slide the top of the mounting plate (1) on the stand under the upper lip of the recess in the back of the panel. 3. Lower the bottom of the stand's mounting plate (2) into the recess until it snaps into place. 4. The HP Quick Release 2 latch (3) pops up when the stand is locked in place. NOTE: If you are mounting the monitor to a mounting fixture instead of the stand refer to Mounting the Monitor on page 19 6 Chapter 3 Setting Up the Monitor

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
Installing the Stand
CAUTION:
Do not touch the surface of the LCD panel. Pressure on the panel may cause non-
uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its
normal condition.
The monitor uses the HP Quick Release 2 for easy mounting and unmounting of the monitor panel.
To mount the panel onto the stand:
1.
Lay the monitor panel face down on a flat surface covered by a clean, dry cloth.
2.
Slide the top of the mounting plate (1) on the stand under the upper lip of the recess in the back
of the panel.
3.
Lower the bottom of the stand's mounting plate (2) into the recess until it snaps into place.
4.
The HP Quick Release 2 latch (3) pops up when the stand is locked in place.
NOTE:
If you are mounting the monitor to a mounting fixture instead of the stand refer to
Mounting
the Monitor
on page
19
6
Chapter 3
Setting Up the Monitor