HP J9087A User Manual - Page 16
Introducing the Switch, Table 1-3., Multiple-Display Port LEDs, Switch LEDs, State, Meaning
View all HP J9087A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Introducing the Switch Introducing the Switch Front of the Switch Table 1-3. Multiple-Display Port LEDs Switch LEDs State Meaning Switch 2626 and Switch 2650 Port LED View Lnk indicator LEDs (4 green LEDs) Act FDx Spd Indicates that the Port LEDs are displaying link information: • if the Port LED is on, the port is enabled and receiving a link indication from the connected device. • if the Port LED is off, the port has no active network cable connected, or is not receiving signal or sufficient light. Otherwise, the port may have been disabled through the switch console or the web browser interface. • if the Port LED is blinking1 simultaneously with the Fault LED, the corresponding port has failed its self test. Indicates the Port LEDs are displaying network activity information. Indicates the Port LEDs are lit for ports that are in full-duplex mode. Indicates the Port LEDs are displaying the connection speed at which each port is operating: • if the Port LED is off, the port is operating at 10 Mbps. • if the Port LED is flashing, the port is operating at 100 Mbps. • if the Port LED is on continuously, the port is operating at 1000 Mbps. Series 2600-PWR Switches LED Mode Act indicator LEDs (4 green LEDs) FDx Indicates the Port Mode LEDs are displaying network activity information. Indicates the Port Mode LEDs are lit for ports that are in full-duplex mode. Spd Indicates the Port Mode LEDs are displaying the connection speed at which each port is operating: • if the Port LED is off, the port is operating at 10 Mbps. • if the Port LED is blinking2, the port is operating at 100 Mbps. • if the Port LED is on continuously, the port is operating at 1000 Mbps. PoE Indicates the Port Mode LEDs are lit for ports that are providing PoE power to the connected device. 1 The blinking behavior is an on/off cycle once every 1.6 seconds, approximately. 2 The blinking behavior is an on/off cycle once every 0.8 seconds, approximately. 1-8