HP J9087A User Manual - Page 47

Installing the Switch 610 EPS LEDs Installing the Switch Installation Procedures Power and Fault LEDs Backup Power Port LEDs EPS Port LEDs 610 EPS hp procurve 610 eps J8169A Pow er Fault Internal Power Status Fan/Temp Status Fan/Temp Status flash = Temperature too high Fan/Temp Status + Fault flash = Fan failure Backup Power Ports Status In Ready Out Ready EPS Ports Pair A (408 W total for PoE applications) EPS A1 A1 Device Connected Power EPS A2 A2 Status EPS Ports: 50V 8.3A max each. Fan/Temp Status LED Internal Power Status LED Power Status LED EPS Ports Pair B (408 W total for PoE applications) EPS B1 B1 Device Connected Power EPS B2 B2 Status Device Connected LED For a complete description of the LEDs see the documentation that came with the 610 EPS. Operating Characteristics of the 610 EPS (J8169A) The 610 EPS does not have any RPS ports and can not supply RPS power. It has four EPS Ports. Two in Pair A and two in Pair B. Each pair can provide a maximum of 408 watts of PoE power to a switch. Again, it is important to understand the PoE power requirements of the switches. For further information regarding the 610 EPS PoE capabilities, see the PoE Planning and Implementation Guide, which is on the Documentation CD-ROM that came with your switch and the documentation that came with the 610 EPS. For redundant or additional PoE power, connect the 610 EPS to the switch using one of the four supplied EPS cables. EPS cables are 2.00 meters (6.56 feet) in length. The following illustration demonstrates and example of connectivity between a 610 EPS device and two Switch devices as a PoE power supply. 2-27