HP Jet Fusion 300 User Guide - Page 87
After calibration, run the Nozzle Health Test on desired bar-Mono D, BF, F or Color Y, M, C, K.
View all HP Jet Fusion 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
4. After calibration, run the Nozzle Health Test on desired bar-Mono (D, BF, F) or Color (Y, M, C, K). ● Results of test are displayed as a table with 4 possible results: ● Results of "OK" and "MON" mean almost no nozzles, or only a few nozzles out, where part quality is unlikely to be affected. ● A result of "RA" means that part quality is likely to be affected in the given region. ● A result of "OUT" means that part quality is very likely to be affected in a larger area. 5. Zones in the Nozzle Health Test Results vs Sections in the Print Quality Diagnostic Plot: Table 14-1 Nozzle Health Test Results vs Sections in the Print Quality Diagnostic Plot Zone # of Nozzle Health Test Section # of Mono Bar Section # of Color Bar Zone 1 Zone 2 Zone 3 A0 & A1 A2 & A3 A4 & A5 D0 & D1 D2 & D3 D4 & D5 Zone 4 A6 & A7 D6 & D7 Zone 5 A8 & A9 D8 & D9 6. Run the Pen Recovery 2 Test to recover printhead health if you see any nozzle health issues: Procedure 81