HP Model 712/100 hp 9000 series 700 model 712 service handbook (a2615-90039) - Page 71
Running Self Test
View all HP Model 712/100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Running Self Test This section explains how to identify a failing FRU through the Self Test graphical display. When you power on the Model 712 workstation, the system runs a series of diagnostic tests, called Self Test, to check the hardware configuration. These tests check all FRUs in the system, including any I/O board in the Expansion Slot. The system displays a screen, similar to the following, while the tests run: BootRom Version xxx.x Memory Size: xx MB Press to stop boot sequence. If an error occurs during the self test, the system displays a second screen depicting an overview of the system unit components, similar to the following: 4-12 Troubleshooting
4–12
Troubleshooting
Running Self Test
This section explains how to identify a failing FRU through the Self Test graphical
display.
When you power on the Model 712 workstation, the system runs a series of diagnos-
tic tests, called Self Test, to check the hardware configuration. These tests check all
FRUs in the system, including any I/O board in the Expansion Slot.
The system displays a screen, similar to the following, while the tests run:
BootRom Version xxx.x
Memory Size: xx MB
Press <ESCAPE> to stop boot sequence.
If an error occurs during the self test, the system displays a second screen depicting
an overview of the system unit components, similar to the following: