HP Nx6325 HP Compaq nx6315, nx6325 Notebook PC - Maintenance and Service Guide - Page 137
Remove the Phillips PM2.0×3.0 screw, Remove the cable from the clips
UPC - 882780649330
View all HP Nx6325 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Removal and Replacement Procedures 2. Position the computer with the rear panel toward you. 3. Release the ZIF connector to which the USB/audio board cable is connected and disconnect the USB/audio board cable 1 from the system board. 4. Remove the Phillips PM2.0×3.0 screw 2 that secures the USB/audio board to the base enclosure. 5. Remove the cable from the clips 3 in the base enclosure. 6. Remove the USB/audio board 4. 7. Release the ZIF connector to which the USB/audio board cable is connected and disconnect the USB/audio board cable 5 USB/audio board. Removing the USB/Audio Board Reverse the above procedure to install the USB/audio board. Maintenance and Service Guide 5-47
Removal and Replacement Procedures
Maintenance and Service Guide
5–47
2. Position the computer with the rear panel toward you.
3. Release the ZIF connector to which the USB/audio board
cable is connected and disconnect the USB/audio
board cable
1
from the system board.
4. Remove the Phillips PM2.0×3.0 screw
2
that secures the
USB/audio board to the base enclosure.
5. Remove the cable from the clips
3
in the base enclosure.
6. Remove the USB/audio board
4
.
7. Release the ZIF connector to which the USB/audio board
cable is connected and disconnect the USB/audio
board cable
5
USB/audio board.
Removing the USB/Audio Board
Reverse the above procedure to install the USB/audio board.